Print Page | Close Window

Gen 1 Showa Fork Seal Issues

Printed From: rsvr.net Forums
Category: RSV / RSVR / FACTORY
Forum Name: Technical Chat
Forum Description: Any technical problems or useful advise for other owners, remember this is just advice posted here, if you make something go BANG in a big way don't take anyone to court about it.
URL: http://www.rsvr.net/forum_posts.asp?TID=29785
Printed Date: 27 Mar 2026 at 02:46
Software Version: Web Wiz Forums 12.07 - https://www.webwizforums.com


Topic: Gen 1 Showa Fork Seal Issues
Posted By: Madreg
Subject: Gen 1 Showa Fork Seal Issues
Date Posted: 23 Nov 2022 at 18:58
Hi, replacing bushes and seals in Showa forks, have the tool etc to seat both bush and the seal, problem is I cannot get the seal to go down far enough to get the retaining clip in. The parts are from "Pyramid Parts" and just wondering if anybody else has probs with them, old seals seem to fit fine.

Many thanks in advance



Replies:
Posted By: 426hemi
Date Posted: 23 Nov 2022 at 21:09
Have you measured the seals to check dimensions?


Posted By: redratbike
Date Posted: 23 Nov 2022 at 21:49
support the shop that runs this site

apworkshops 

parts that fit yes more expensive than pyramid parts no doubt but they work 

https://www.apworkshops.co.uk/search/fork+seals/" rel="nofollow - https://www.apworkshops.co.uk/search/fork+seals/


-------------




Posted By: Madreg
Date Posted: 24 Nov 2022 at 08:34
All, checked the dimensions and all seem to be ok, did have issues with the bottom bush and had to send back, seems these Pyramid parts are not a good fit.

New to this site so yes will support APW and order from them

Cheers



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.07 - https://www.webwizforums.com
Copyright ©2001-2024 Web Wiz Ltd. - https://www.webwiz.net