No Start error message

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi All
While in traffic my 2001 Falco cut out and when I pressed the starter button I the bike wouldn't start and the message "NO START" flashed in the right hand console screen. The engine Temp was 89C. When  I switched  the ignition off/on and then tried it again the bike started but cut out again when I tried to pull away. It did this 3 times and then ran normally and hasn't happened again so far. Anyone have any clues as to the cause and remedy?
Thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
seascan Members Profile Send Private Message Find Members Posts Add to Buddy List L Plates Joined: 11 Feb 2008 Status: Offline Points: 6	Post Options Post Reply Quote seascan Report Post Thanks(0) Quote Reply Topic: No Start error message Posted: 27 Feb 2009 at 08:51
	Hi All While in traffic my 2001 Falco cut out and when I pressed the starter button I the bike wouldn't start and the message "NO START" flashed in the right hand console screen. The engine Temp was 89C. When I switched the ignition off/on and then tried it again the bike started but cut out again when I tried to pull away. It did this 3 times and then ran normally and hasn't happened again so far. Anyone have any clues as to the cause and remedy? Thanks

Spoonz Members Profile Send Private Message Find Members Posts Add to Buddy List Admins Group Joined: 11 Feb 2008 Location: North Devon Status: Offline Points: 10957	Post Options Post Reply Quote Spoonz Report Post Thanks(0) Quote Reply Posted: 27 Feb 2009 at 09:17
	sounds like it may be the sidestand switch. If it thinks the stand is down then it will cut the engine as soon as you let the clutch out if in gear. It's not uncommon for them to fail either. you can try cleaning it up with switch cleaner but they are often coroded internally and require a new one. You don't want it to cut out on you mid corner or something.

scottyni Members Profile Send Private Message Find Members Posts Add to Buddy List Premium Member Joined: 11 Feb 2008 Location: N/Ireland, Status: Offline Points: 26	Post Options Post Reply Quote scottyni Report Post Thanks(0) Quote Reply Posted: 29 Jul 2009 at 21:33
	prob sorted out but check the wires as mine did the same. just took my switch off completely. get replacement whenever.
	if you can't ride it... or take it too bed..... IT AIN'T WORTH HAVIN..!

Nate Members Profile Send Private Message Find Members Posts Add to Buddy List L Plates Joined: 23 Jul 2009 Location: Staffs, England Status: Offline Points: 6	Post Options Post Reply Quote Nate Report Post Thanks(0) Quote Reply Posted: 23 Aug 2009 at 19:00
	Does your bike run with the stand down? N.

cheesy Members Profile Send Private Message Find Members Posts Add to Buddy List Premium Member top chef! Joined: 11 Feb 2008 Location: Peterborough Status: Offline Points: 1761	Post Options Post Reply Quote cheesy Report Post Thanks(0) Quote Reply Posted: 24 Aug 2009 at 18:35
	also check the tip over switch is the right way round
	04 Tuono Fighter 1060 gen2 motor & some....