Print Page | Close Window

Torque setting for rear axle nut

Printed From: rsvr.net Forums
Category: General Chat
Forum Name: General Chat
Forum Description: Just Chat about life and its myriad of challenges.
URL: http://www.rsvr.net/forum_posts.asp?TID=26273
Printed Date: 14 Nov 2018 at 23:36
Software Version: Web Wiz Forums 12.00 - http://www.webwizforums.com


Topic: Torque setting for rear axle nut
Posted By: Stevex
Subject: Torque setting for rear axle nut
Date Posted: 13 Jan 2018 at 18:19
Although the 'book quotes 120NM for a Gen 1 rear wheel axle nut, I'm sure I've read that this is too high and 100NM is recommended. Can anyone confirm this please?

-------------
People say I don't know Jack Sh1t; but I do, he lives next door.



Replies:
Posted By: 426hemi
Date Posted: 13 Jan 2018 at 18:22
I do mine to 100 on all my bikes .


Posted By: legend88
Date Posted: 13 Jan 2018 at 19:34
I think 90 - 100 seems to be the consensus. I'm sure there was some mention of an update to the Aprilia recommendation due to damage to wheel bearings using 120?


Posted By: felix
Date Posted: 13 Jan 2018 at 22:03
It was 120 nm...

I recall Griff posting that this should be reduced to 100 nm as the rear wheel bearing spacer suffered....


Posted By: Stevex
Date Posted: 14 Jan 2018 at 09:47
Thanks for the confirmation, done up to 100NM.

-------------
People say I don't know Jack Sh1t; but I do, he lives next door.


Posted By: FTM
Date Posted: 14 Jan 2018 at 10:06
I'll remember that figure next time I mess with the wheel. I usually just tighten by feel, if it feels right then it's good.


Posted By: snowman
Date Posted: 14 Jan 2018 at 18:00
Yep, 100 NM rear, 80 NM front always on mine no bother so far . Plus I always check my T/Wrench regular on calibrated gauge at work as once I snapped some bolts (MGB head bolts ) where it was miles out . Not the one I use now ,.



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.00 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net