rsvr.net Forums Homepage
Forum Home Forum Home > RSV / RSVR / FACTORY > FAQ
  New Posts New Posts RSS Feed - gen1 flywheel weight
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


gen1 flywheel weight

 Post Reply Post Reply
Author
Message
tonyt3892 View Drop Down
Moto GP Alien
Moto GP Alien
Avatar

Joined: 21 Dec 2014
Location: lancashire
Status: Offline
Points: 314
Post Options Post Options   Thanks (0) Thanks(0)   Quote tonyt3892 Quote  Post ReplyReply Direct Link To This Post Topic: gen1 flywheel weight
    Posted: 28 Jan 2015 at 22:17
anyone removed this on a gen1
a thomas
Back to Top
Throbbing-Twin View Drop Down
Premium Member
Premium Member
Avatar

Joined: 14 Jan 2014
Location: Gosport
Status: Offline
Points: 1394
Post Options Post Options   Thanks (0) Thanks(0)   Quote Throbbing-Twin Quote  Post ReplyReply Direct Link To This Post Posted: 28 Jan 2015 at 22:22
The actual flywheel rotor? If so yes on a gen 1. Not easy. Need the correct puller and plenty of heat. And I'm not joking plenty of heat and a good pair of heat proof gloves to hold it as it pops off so it doesn't hit the ground.
If its not broken then fix it until it is
Back to Top
Throbbing-Twin View Drop Down
Premium Member
Premium Member
Avatar

Joined: 14 Jan 2014
Location: Gosport
Status: Offline
Points: 1394
Post Options Post Options   Thanks (0) Thanks(0)   Quote Throbbing-Twin Quote  Post ReplyReply Direct Link To This Post Posted: 28 Jan 2015 at 22:24
Had to change my sprag which required removing the rotor. Also advise using the correct loctite fluid when reinstalling it too.
If its not broken then fix it until it is
Back to Top
Spoonz View Drop Down
Admins Group
Admins Group


Joined: 11 Feb 2008
Location: North Devon
Status: Offline
Points: 10726
Post Options Post Options   Thanks (0) Thanks(0)   Quote Spoonz Quote  Post ReplyReply Direct Link To This Post Posted: 28 Jan 2015 at 22:46
Originally posted by tonyt3892 tonyt3892 wrote:

anyone removed this on a gen1

The Gen1 flywheel weight is riveted on and also acts as a spacer. So you would have to first drill out the rivets and secondly replace it with something to keep the spacing the same.
 
I did remove mine on a Gen2, but it only made a small difference and the bike did stall a little easier so I put it back on.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.078 seconds.