rsvr.net Forums Homepage
Forum Home Forum Home > General Chat > Technical info
  New Posts New Posts RSS Feed - Crank flywheel lapping
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Crank flywheel lapping

 Post Reply Post Reply
Author
Message
Mack 1 View Drop Down
L Plates
L Plates
Avatar

Joined: 11 Jan 2020
Location: Plymouth
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote Mack 1 Quote  Post ReplyReply Direct Link To This Post Topic: Crank flywheel lapping
    Posted: 20 Jan 2020 at 16:13
Would it be worth centre punching around the stator end of the crank as this is the second time it's slipped. Loctite green used. Thought about a second hand flywheel I think it's good money after bad. Gen 1- 18000 on the clock 
Owned since new. 
Back to Top
Prsv View Drop Down
Premium Member
Premium Member


Joined: 29 Jan 2016
Location: Fareham
Status: Offline
Points: 555
Post Options Post Options   Thanks (0) Thanks(0)   Quote Prsv Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jan 2020 at 07:30
Was the bolt torque correct and lock tight on threads not taper.
Edit just checked workshop manual, torque 130 n-m , 95.88 ft-lb, loctight 648
Back to Top
Mack 1 View Drop Down
L Plates
L Plates
Avatar

Joined: 11 Jan 2020
Location: Plymouth
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote Mack 1 Quote  Post ReplyReply Direct Link To This Post Posted: 04 Feb 2020 at 18:57
All correct torque the keyway is a bit shot so need to stop the woodruff key from moving not Jb or 648.when I took the flywheel off the key was in the rotor slot which is not good. So the key is moving which is putting out timimg So need to get some strong metal compound. 
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.156 seconds.