rsvr.net Forums Homepage
Forum Home Forum Home > RSV / RSVR / FACTORY > FAQ
  New Posts New Posts RSS Feed - Fitting AP rearsets
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Fitting AP rearsets

 Post Reply Post Reply
Author
Message
canmam View Drop Down
Moto3 racer
Moto3 racer
Avatar

Joined: 25 Apr 2013
Status: Offline
Points: 21
Post Options Post Options   Thanks (0) Thanks(0)   Quote canmam Quote  Post ReplyReply Direct Link To This Post Topic: Fitting AP rearsets
    Posted: 22 Jun 2013 at 20:42
So finally sorted myself out with some AP rearsets, Can anyone help with the fitting? left side is straightforward but not too sure  about moving master and res. Is it a hard job or should i book it in? 
Market Harborough Motorcycle Group Facebook.
Back to Top
pauloblade View Drop Down
Moto2 racer
Moto2 racer


Joined: 10 Jun 2012
Location: Sheffield
Status: Offline
Points: 116
Post Options Post Options   Thanks (0) Thanks(0)   Quote pauloblade Quote  Post ReplyReply Direct Link To This Post Posted: 23 Jun 2013 at 08:40
 im gonna be fitting some aswell hopefully next wknd on my gen1 tuono.if they arrive in time. also after any tips people have on moving the master cylinder etc.
Back to Top
WARNZ View Drop Down
Premium Member
Premium Member
Avatar

Joined: 10 May 2012
Location: Essex
Status: Offline
Points: 1171
Post Options Post Options   Thanks (0) Thanks(0)   Quote WARNZ Quote  Post ReplyReply Direct Link To This Post Posted: 23 Jun 2013 at 11:35
There's some pics on here somewhere on how to run the brake line,loop up through we're the shock is in the swingarm n then on to m/c n snip the switch wires off the old sensor re route behind frame to battery area then down to new switch solder wires n shrink em job done butt I would put a little loctite on everything as mine vibrated loose
Back to Top
canmam View Drop Down
Moto3 racer
Moto3 racer
Avatar

Joined: 25 Apr 2013
Status: Offline
Points: 21
Post Options Post Options   Thanks (0) Thanks(0)   Quote canmam Quote  Post ReplyReply Direct Link To This Post Posted: 23 Jun 2013 at 18:18
loctite lol just took the old ones off and one of bolts snapped leaving 10mm showing will try and get some moles on it or will have to drill it out. Was looking at some pics of the switch and i see you put it on top of the master cylinder, how does that work?
Market Harborough Motorcycle Group Facebook.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.109 seconds.